Rebuilt the centre arm assembly to eliminate the steering slop that was noticed on rego inspection. Should also stop it from floating on the road and go in a straight line.


Centre Arm Assembly causing steering slop.


Top adjusting nut taken off.


Belting the cone shaft to free the relay arm from the cetre arm assembly.


The bits fall out. The cone swivels on a brass bushing that wears out.


New parts from Roodog. Locking bolt, adjusting bolt, washer, spring, bushing, cone, seal, spring washer, nut in the kit.


Smearing grease on everything prior to installation.


Greasy. Bushing and Cone in place.


Relay arm attached to centre arm assembly.


Bit of a gap, but apparently that's normal.


Back on the cruiser, just needs some final adjustments.